|Home||» Products||» CRC Spray||» CRC LECTRA CLEAN - CLEANER AND DEGREASER|
Non-flammable electrical parts cleaner. CRC Lectra Clean is a heavy duty degreaser with strong cleaning action and fast evaporation.The chlorinated solvent blend is designed to quickly and effectively clean electrical/mechanical components, preventing failures and malfunctions caused by contaminants such as dust, dirt, grease and oil.
Contains no ozone depleting chemicals: ODP = 0.
Gives no contribution to global warning : GWP = 0.
Very low ozone creation potential : OCP : 0,05.
Promotes operating efficiency.
Contributes to prolonged equipment life.
Evaporates quickly and leaves no residue.
Non-staining, non-corrosive and non-conductive.
No flash point.
May be harmful to some plastics, rubbers, adhesives and paints. (Test prior to use.)
Aerosols are equipped with the 360° (upside-down) spray valve for added convenience.
Pressurised with non-flammable CO2 propellant, giving an active product content of 97%.
An effective heavy duty degreaser for :
Chains & Wire ropes
Dies & molds
Mechanical brakes & clutches
Corroded machinery and parts.
Apply liberally by spraying or dipping and allow excess to run off. Use extension tube for hard-to-reach areas. In dipping bath applications, agitation enhances cleaning action. May also be applied by wiping or by brushing.To clean equipment interior, covers, plates, etc. should be removed prior to product application.
Allow to air dry or dry with absorbent cloth. After cleaning, use CRC 2-26 for lubrication and protection.
Do not use on sensitive electronic equipment such as tape desks,VCRâs, computers, etc. Use one of CRCâs contact cleaner products for this.
Use only in well ventilated area.
A safety data sheet (MSDS) according EU93/112 is available for all CRC products.
Appearance : clear liquid
Odour : chlorinated solvent
Distillation range : 85-125°C
Freezing point : < -20°C
Specific gravity (@ 20°C) : 1,50
Vapour density (vs. air = 1) : > 4
Kauri-Butanol value : 125
Flash point (closed cup) : none
Evaporation rate (vs. ether = 1) : 4
Non-volatile content : < 50 ppm
Surface tension (@ 20°C) : 32 mN/m
Dielectric constant (@ 1000 Hz) : 3,0 ± 0,5
Drying time (vertical)(**) : < 0,5 hrs.
aerosol : 12 x 400 ml
bulk : 4 x 5 L