CRC Copper Paste Aerosol Spray

Product Description

• Reduces friction and wear, even when the base oil has already evaporated.
• High pressure and high temperature resistance.
• Ensures accurate assembly.
• Enables easy disassembly of threaded parts, gaskets and flanges, even after long operational periods.
• Threaded parts remain in good condition and can be re-used.
• Separating film ensures favourable release behaviour of the threaded connections.
• Excellent sealing even in corrosive atmospheres.
• Resistant to hot and cold water.
• Lead-free and nickel-free.
• Aerosol formulation does not contain chlorinated solvents and uses hydrocarbon propellant.

• Bolts, nuts, pins
• Screw connections on hydraulic equipment
• Guides for brakes
• Bushings, fittings
• Brake adjusters
• Spark plugs
• Splines

• Wheel screws
• Flanges, flange seals
• Pipeline connections
• Exhaust screw connections
• Linkages
• Sliding sleeves / shafts
• Press fits.

• A thin, even film should be applied either by spraying or by brushing.
• Assembled parts (gear teeth, screws) can slowly be put in motion.
• Avoid mixing with other products.
• Test before use on plastics or rubber.
• Do not use on energised equipment, oxygen systems or in presence of acetylene.
• Use aerosol only in ventilated areas.
• A safety data sheet (MSDS) according EU directive 93/112 is available for all CRC products.

• Appearance : homogenous, copper coloured
• Aerosol properties
• Flash point (open cup) : < 0°C
• Boiling range (solvent) : 60-95°C
• Vapour density (vs. air=1) : 3
• Specific gravity (@ 20°C) : 0,81
• Dry film properties
• Specific gravity (@ 20°C) : 0,99
• Flash point (open cup) : > 200°C
• Dropping point : none
• NLGI consistency : 1 - 2
• Low temperature stability : -30°C
• Temperature resistance **
• lubrication : 300°C
• anti-seize : 650°C
• Hot water resistance (DIN 51807 T1, 40°C, 90°C) : 1
• Corrosion (DIN 51802) : 0/0
• Four Ball Wear (DIN 51350 T5, 1h, 500N) : 0,5 mm

• aerosol : 12 x 300 ml
• tubes : 12 x 100 ml
• bulk : 12 x 500 g